The Charnwood W660 10'' Panel Saw is ideal for handling large panels, anything up to an 8’ x 4’ sheet. The sliding beam of this table saw, runs on a set of bearings along a sturdy support bed with additional support legs at each end. This gives a very smooth action with a high degree of accuracy. The beam can be locked in position when using the rip fence.
The extension table is also supported by a telescopic arm to take the weight of larger panels. The squaring arm at the rear of the table can be adjusted at any angle up to 45 degrees and is fitted with a flip over stop for repeat measurements.
For crosscutting smaller pieces we also provide a mitre fence which locks onto the sliding beam and can be adjusted to any angle from 90 to 45 degrees.
Motor (Induction): 2200w (3hp) 240v
No-load Blade Speed: 4000rpm
Main Table Size: 650mm x 620mm
Maximum Ripping Width Using Fence: 610mm
Crosscut Table Size: 400mm x 180mm
Maximum Crosscutting Width: 1225mm
Blade Tilt 90 - 45 Degrees
Cutting Depth at 90 Degrees: 80mm
Cutting Depth at 45 Degrees: 56mm
Blade Diameter: 250mm
Blade Bore: 30mm
Work Table Height: 830mm
Dimensions (WxDxH): 1330mm x 1500mm x 1120mm
Db (Without Load/With Load): 81Db/89.5Db
12 Months Guarantee!